The printer will now automatically search for access points supporting the WPS feature.
Use the arrow buttons (C) to select and press the button.
Most WPS enabled access points use this protocol.
Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.
If the WPS push button is not available please use the instructions in the Standard Connection Method. The access point must have a physical WPS push button available. Please check with your device’s user guide for details. Disable the connection between the device and printer in the Wi-Fi setting screen.Before we start, there are some conditions that must be met in order to use the WPS push button method:
When a device has been connected to the printer without using a wireless router and you want to set it up again, disconnect it first.
Firmware updates for the printer are not available while using Direct Connection.
Devices connected to the printer using Direct Connection cannot communicate with each other.
If an error appears, disconnect a device that does not use the printer, then configure settings again.
If you try to connect a sixth device while five devices are already connected, an error will appear.
In Direct Connection mode, you can connect up to five devices at the same time.
In that case, web services for the printer cannot be used.
If you connect a device and the printer using Direct Connection, Internet connection may become unavailable depending on your environment.
#Canon mx492 wireless setup pc how to
To prevent automatic connection to the printer in Direct Connection mode, change the connection mode after using the printer, or set not to connect automatically in the Wi-Fi settings of the device.įor details on how to change the settings of a device, refer to the manual supplied with the device or contact its manufacturer.
If you have a wireless router, we recommend that you use the wireless router to connect to the printer.
You cannot connect to a wireless router and a printer in Direct Connection mode at the same time.
The device may be connected to the printer automatically even after disconnecting it or connecting it to another wireless router.
When you connect a device and the printer using Direct Connection, the connection information will be saved to Wi-Fi settings.
When you connect to the Internet using a mobile data connection, charges may apply depending on your contract. In that case, the connection of the device may switch to a mobile data connection automatically depending on your device.
If a device is connected to the Internet via a wireless router, and you then connect it to a printer in Direct Connection mode, the existing connection between the device and wireless router will be disabled.
Note that if you connect to a network with no security protection, your personal information could be disclosed to a third party.
For office use, consult your network administrator.
Do not proceed to the next screen of this guide until setup is complete. The connection between your device and the wireless router will be temporarily disabled while the setting is changed. Change the security protocol for your device to something other than WEP and TKIP or change the setting to something other than " IEEE802.11n only."
If your device is set to the " IEEE802.11n only" mode, WEP or TKIP cannot be used as a security protocol.
For details, see the manual for your network device or contact its manufacturer.
Configuration, router functions, setup procedures and security settings of network devices vary depending on the system environment.
For how to check the settings, see the manual supplied with the wireless router, or contact its manufacturer.Īs for a device already connected to the printer without using a wireless router, reconnect it via a wireless router.
Check that the device is connected to a wireless router.
This printer cannot be used over Wi-Fi and via wired LAN connection (Ethernet cable) at the same time.